Introducing the OmniBook
Setting Up for the First Time
User’s Handbook 15
Setting Up for the First Time
When you set up the OmniBook for the first time, you’ll need to install and charge the
battery, connect the ac adapter, turn on the OmniBook, and go through the Windows
setup program.
To set up the OmniBook and Windows
CAUTION
Use only the HP adapter shipped with the OmniBook (or other approved adapter).
Using any other ac adapter could damage the OmniBook and may void your
warranty. Refer to the warranty statement for your product.
1. Install the OmniBook battery (see the Quick Start sheet or “To replace the battery” on
page 49).
2. Plug in the ac adapter.
3. Connect the ac adapter to the OmniBook’s right side, as shown. The OmniBook
battery starts charging.
Let the battery charge a full 24 hours to completely charge the internal clock battery.
Otherwise, the OmniBook may not keep the correct date and time.
To Next Page
Loading...
Need help?
General