Introducing the OmniBook
Setting Up for the First Time
User’s Handbook 17
For suggestions about taking care of your OmniBook, see the chapter titled “Operating
the OmniBook” in the online Reference Guide.
To connect the floppy disk drive
1. Insert the floppy disk drive into the external module bay. If this is your only plug-in
module, you can leave it in the module bay.
2. On the right side of the OmniBook, open the flap covering the module bay connector
and plug in the module bay cable. The computer can be on or off.
To remove the floppy drive, you must shut down or notify Windows before you unplug
the module or the module bay. See “To remove or install the bay or module” on page 53.
CAUTION
Do not touch the metallic pins in OmniBook connectors, module connectors, or
cable connectors. Static electricity can damage internal components.
To Next Page
Loading...
Need help?
General