Troubleshooting
Solving Problems
72 User’s Handbook
Solving Problems
If your OmniBook has a problem, find the symptom below that matches your situation.
Try the suggestions one at a time.
Here are some other sources of information:
• Click Start, Help and use the Windows Troubleshooters.
• See the Microsoft Windows manual shipped with the OmniBook.
• For information about system addresses, interrupts, DMA channels, or memory, see
the chapter titled “Specifications and Regulatory Information” in the online Reference
Guide.
• Find technical tips and software updates for the OmniBook at the HP Customer Care
website (http://www.hp.com/cposupport/eschome.html).
• Test your OmniBook by running the DiagTools test program. See “To run the
diagnostic test” on page 90.
• Contact your dealer or Hewlett-Packard—see “Support Assistance” on page 96.
Please have your OmniBook with you.
Note
For Windows NT, if you install new services, hardware devices, or applications, you
must reinstall the Service Pack from the Recovery CD—see OmniBook Notes in the
online OmniBook Library. This ensures that the Service Pack components work
properly. It will not write over any applications, settings, or drivers you have installed.
Accessory Problems
If a port on a dock isn’t working
• Check that ac power is connected to the dock.
• Try using the corresponding OmniBook port, while undocked.
• Make sure the OmniBook is fully inserted in the dock.
• See the manual for the dock.
If you can’t boot from a CD in a CD-ROM drive
• Make sure the CD is a bootable CD, such as the OmniBook Recovery CD.
To Next Page
Loading...
Need help?
General