Expanding the OmniBook
Installing a RAM Expansion Module
64 User’s Handbook
8. Fold the keyboard back into place. Slip the front tabs into the slots, then snap the back
edge into place.
9. Insert the two screws at the top of the keyboard.
10. Lower the plastic panel about 3 mm (1/8 inch) from its normal position. Hold down
both ends and slide it closed to the right.
11. Insert the battery and slide its front panel to the left.
To remove the RAM board, release the two latches at the sides of the board.
To Next Page
Loading...
Need help?
General