HP ProCurve Switch 2650 User Manual

4-20
Configuring Secure Shell (SSH)
Configuring the Switch for SSH Operation
Figure 4-13. Configuring for SSH Access Requiring a Client Public-Key Match and Manager Passwords
Figure 4-14 shows how to check the results of the above commands.
Figure 4-14. SSH Configuration and Client-Public-Key Listing From Figure 4-13
Configures Manager user-
name and password.
Configures the
switch to allow
SSH access only a
client whose
public key
matches one of the
keys in the public
key file
Configures the primary and
secondary password methods for
Manager (enable) access. (Becomes
available after SSH access is granted
Copies a public key file
named "Client-Keys.pub"
into the switch.
Lists the current SSH
authentication
config- uration.
Shows the contents of
the public key file
downloaded with the
copy tftp command in
figure 4-13. In this
example, the file
contains two client
!FishSecurity.book Page 20 Thursday, October 10, 2002 9:19 PM

HP ProCurve Switch 2650 Specifications

General

Switching Capacity	13.6 Gbps
Forwarding Rate	10.1 Mpps
Layer	Layer 2
Form Factor	Rack-mountable
Flash Memory	8 MB
Jumbo Frame Support	Yes
Power Supply	Internal
Management	Web, CLI, SNMP
Features	VLAN support, IGMP snooping, QoS
Operating Temperature	0°C to 45°C (32°F to 113°F)
Operating Humidity	15% to 95% (non-condensing)
Ports	48 x 10/100
MAC Address Table Size	8, 000 entries