HP ProCurve Switch 2650 User Manual

2-3
TACACS+ Authentication
Overview
server and (2) local passwords configured on the switch. That is, with
TACACS+ configured, the switch first tries to contact a designated TACACS+
server for authentication services. If the switch fails to connect to any
TACACS+ server, it defaults to its own locally assigned passwords for authen-
tication control if it has been configured to do so. For both Console and Telnet
access you can configure a login (read-only) and an enable (read/write)
privilege level access.
Notes Regarding
Software
Release H.07.xx
Software release H.07.xx (or greater) for the Switch 2650 and 6108 enables
TACACS+ authentication, which allows or denies access to a Switch 2650 and
6108 on the basis of correct username/password pairs managed by the
TACACS+ server, and to specify the privilege level to allow if access is granted.
This release does not support TACACS+ authorization or accounting services.
In release H.07.xx, TACACS+ does not affect web browser interface access.
See "Controlling Web Browser Interface Access" on page 2-24.
!FishSecurity.book Page 3 Thursday, October 10, 2002 9:19 PM

HP ProCurve Switch 2650 Specifications

General

Switching Capacity	13.6 Gbps
Forwarding Rate	10.1 Mpps
Layer	Layer 2
Form Factor	Rack-mountable
Flash Memory	8 MB
Jumbo Frame Support	Yes
Power Supply	Internal
Management	Web, CLI, SNMP
Features	VLAN support, IGMP snooping, QoS
Operating Temperature	0°C to 45°C (32°F to 113°F)
Operating Humidity	15% to 95% (non-condensing)
Ports	48 x 10/100
MAC Address Table Size	8, 000 entries