HP ProLiant DL345 Gen10 Plus - Removing and Replacing a DIMM

Removing and replacing a DIMMRemoving and replacing a DIMM
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel.
5. Remove the air baffle.
6. Remove the DIMM.
To replace the component, reverse the removal procedure.
For DIMM configuration information, see the server user guide.
Removing and replacing a DIMM 101