Removing and replacing an acceleratorRemoving and replacing an accelerator
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the server from the rack
4. Remove the access panel.
5. For full-lenght accelerators, release the expansion board retainers .
6. Remove the air baffle.
7. Disconnect the corresponding accelarator power cable.
To Next Page
Loading...
