HP ProLiant DL345 Gen10 Plus - Removing and Replacing the SFF Front I;O Module

Removing and replacing the SFF front I/O moduleRemoving and replacing the SFF front I/O module
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel.
5. Remove the air baffle.
6. Disconnect the front I/O module cable.
7. Remove the SFF front I/O module.
To replace the component, reverse the removal procedure.
Removing and replacing the SFF front I/O module 129