Replacing the system boardReplacing the system board
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-15 screwdriver (for system board screws)
T-20 screwdriver for processor and heatsink screws
Alcohol wipe
Thermal grease (spare part number 777298-001)
ProcedureProcedure
1. Install the spare system board.
2. Use a screwdriver to loosen the three captive screws in the sequence shown and then pivot the force frame up.
3. Remove the external cap.
a. Hold the lift tabs near the front end of the rail frame, and then pivot the rail frame to the vertical position.
To Next Page
Loading...
