Removing and replacing a type-a modular storage controllerRemoving and replacing a type-a modular storage controller
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel.
5. Remove the air baffle.
6. Disconnect all cables from the storage controller.
7. Remove the storage controller.
To replace the component, reverse the removal procedure.
To Next Page
Loading...
