HP ProLiant DL345 Gen10 Plus - Removing and Replacing the Chassis Intrusion Detection Switch

Removing and replacing the chassis intrusion detection switchRemoving and replacing the chassis intrusion detection switch
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the server from the rack
4. Remove the access panel.
5. Remove the chassis intrusion detection switch.
To replace the component, reverse the removal procedure.
Removing and replacing the chassis intrusion detection switch 131