Removing and replacing a hot-plug SAS, SATA or NVMe driveRemoving and replacing a hot-plug SAS, SATA or NVMe drive
CAUTION: CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated
with either a component or a blank.
ProcedureProcedure
1. Back up all server data on the drive.
2. If installed, remove the front bezel .
3. Observe the drive LED status and determine if it can be removed.
4. Remove the drive.
LFF drive
SFF drive
To replace the component, reverse the removal procedure.
To Next Page
Loading...
