a. Position the heatsink on top of the processor, ensuring that it is properly seated before securing the screws.
b. Use a T-20 screwdriver to tighten the captive screws in the sequence specified on the heatsink label until fully seated.
9. Install all components removed from the failed system board.
10. Install the access panel.
11. Install the power supplies.
12. Power up the server.
13. Ensure all firmware, including option cards and embedded devices, is updated to the same versions to ensure that the latest drivers
are being used.
14. Re-enter any Secure Boot Keys that were previously added in the Secure Boot configuration.
15. Re-enter the server serial number and product ID .
To Next Page
Loading...
