HP Sprout - System Backup, Recovery, and Restoration; Creating Recovery Media and Backups

3. Lift the top of the memory cover to disengage it from the computer (1), and then remove the cover (2).
4. Spread the two retention clips outward (1) until the memory module tilts up at a 45-degree angle.
Remove the module (2). Use the same procedure to remove both memory modules.
NOTE: A memory module can be installed in only one way. Match the notch on the module with the tab
on the memory socket.
The computer automatically recognizes the additional memory when you turn on the computer.
ENWW Memory 31