Xen Citrix SAN rules
This section describes the SAN rules for Xen.
For current storage system support, see the SPOCK website at http://www.hp.com/storage/spock.
You must sign up for an HP Passport to enable access.
Table 113 describes SAN rules for Xen
Table 113 Xen SAN configuration rules
Xen SAN rulesStorage systems
1
• Supports multipathing high-availability configuration in multiple fabrics or in a single fabric with
zoned paths.
All supported
• Zoning is required when Xen is used in a heterogeneous SAN with other operating systems.
• For HBA parameter settings, see Table 117 on page 237.
• Supports boot from SAN
• Supports Device Mapper 4.3
MSA2000fc G2
(MSA2300fc)
MSA2000fc
• Zoning is required when Xen is used in a heterogeneous SAN with other operating systems.
• Supports active/active or active/passives failover mode.
• Supports boot from SAN. For more information, see “XP and VA SAN boot support” on page 268.
XP20000
XP24000
XP10000
XP12000
• Zoning is required when Xen is used in a heterogeneous SAN with other operating systems.
• Supports connection of single HBA servers.
• Supports boot from SAN. For more information, see “EVA SAN boot support” on page 256.
• For HP Continuous Access EVA configuration information, see “HP Continuous Access EVA SAN in-
tegration” on page 254.
EVA6400
EVA8000
EVA8100
EVA8400
EVA4000
EVA4100
EVA4400
EVA6000
EVA6100
1
Unlisted but supported storage systems have no additional SAN configuration restrictions. For the latest support information, contact an
HP storage representative.
SAN Design Reference Guide 231
To Next Page
Loading...
