B-series MP Router features and requirements
Table 152 lists the features and requirements for the MP Router.
Table 152 B-series MP Router features and requirements
RequirementsFeature
The MP Router is supported with the B-series switches listed in “B-series switches and
fabric rules” on page 93. The MP Router is not supported for use as a Fibre Channel
switch. Direct device connectivity to MP Router ports (F_Ports) is supported only with
iSCSI (see “iSCSI storage” on page 355).
Switches for iSCSI and FCIP
TCP/IP IPv4, Ethernet 10 Mb/s, 100 Mb/s, and 1,000 Mb/s
Requires dedicated IP bandwidth, see Table 157 and Table 161.
Note: You can only use optical GbE compatible connections to the FCIP or iSCSI ports.
IP network protocols
Continuous Access EVA
Continuous Access XP20000/24000, XP10000/12000, XP128/1024, XP48/512
See “Heterogeneous server rules” on page 185 for operating system support.
Note: B-series MP Router ports used for Continuous Access EVA must have the
exchange-based routing feature disabled. Use the following command to disable
exchange-based routing across FCIP port processors:
portCfgFcip -m 2
FCIP portcfgfcip [-m LOAD_BAL (1-exchange, 2-SID_DID, 3-none]
The default is 1. You must set this value to 2 or 3 for Continuous Access EVA.
XP Continuous Access supports exchange-based routing, SID-DID, or none.
Storage systems
For Continuous Access EVA, see the HP StorageWorks Enterprise Virtual Array
compatibility reference matrix at http://h18006.www1.hp.com/products/storage/
software/conaccesseva/index.html.
FCIP-supported operating systems
For information about the MP Router, see the MP Router website:
http://h18006.www1.hp.com/products/storageworks/mprouter/index.html
Documentation
SAN extension320
To Next Page
Loading...
