HP StorageWorks 4000/6000/8000 - Enterprise Virtual Arrays - XP Continuous Access Ifcp Gateway Support

Table 177 XP Continuous Access iFCP gateway support
NotesXP storage system
Product and minimum
supported firmware
version
• Firmware earlier than 1.5.1 requires a remote switch license
• Supported switches: B-series 2400/2800, FC8B, and FC16B; M-series:
Edge 2/16, 2/24, and 2/32
• Data compression possible
Note: This converter has been discontinued. There is limited support for existing
installations.
XP1024
XP128
XP512
XP48
Brocade-McDATA-CNT
Edge 1000 and 1100
Firmware: 1.5.1.2.7
• Firmware earlier than 1.5.1 requires a remote switch license
• Supported switches: B-series 2400/2800, FC8B, and FC16B; M-series
Edge 2/16, 2/24, and 2/32
1
• Data compression possible
Note: This converter has been discontinued. There is limited support for existing
installations.
XP1024
XP128
XP512
XP48
Brocade-McDATA-CNT
Edge 1001 and 1101
FC
Firmware: 1.5.1.2.7
• Supported switches: B-series 2/128, 2/64, 2/32, 2/16, 2/8, 2800,
and 2400
1
• Can be used in FCIP direct configuration
• Data compression possible
•
No remote switch license required
1
• Maximum transmission rate from 16 Mb/s to 1 Gb/s
XP1024
XP128
XP512
XP48
XP24000
XP20000
XP12000
XP10000
Brocade-McDATA-CNT
Edge 3000
Firmware: 3.1.1.3,
3.1.2, 3.1.4, 3.1.5
Contact an HP storage representative.XP128
XP512
XP48
XP12000
XP10000
XP1024
McDATA-Nishan
IPS3300
Contact an HP storage representative.XP128
XP512
XP48
XP12000
XP10000
XP1024
McDATA-Nishan
IPS4300
• Supported switches: M-series Edge Switch 2/12, 2/16, 2/24, 2/32;
Director 2/140, 2/64; McDATA 4400, 4700
• Can be used as a switch and iFCP gateway with XP storage systems
nl
directly connected
XP1024
XP128
XP512
XP48
(1620 only
for
XP512/48)
XP24000
XP20000
XP12000
XP10000
McDATA Eclipse 2640
and 1620
Firmware: 4.07 or 4.4.0
SAN Design Reference Guide 351