NotesXP storage system
Product and minimum
supported firmware
version
• Supported switches: B-series 2400/2800, FC8B, and FC16B
• Requires a remote switch license
• Interoperability mode = 1, E_D_TOV = 5,000
Note: This converter has been discontinued. There is limited support for existing
installations.
XP1024
XP128
XP512
XP48
Brocade-McDATA-Inrange
9801 SNS
Firmware: 2.3 (Build 28)
or 2.4 (Build 13)
1
With McDATA-CNT Edge firmware 1.5.1 and B-series switches, ISL R_RDY mode = ON must be set on the E_Port of the switch (portcfgIS-
LMode = 1). For B-series switches using firmware 2.x, a remote switch license is required. E_D_TOV = 5,000, R_A_TOV = 10,000,
DataFieldSize = 2,048.
Table 178 XP Continuous Access ESCON IP gateway support
Minimum IP bandwidth per
path
Product and minimum supported firmware
versionConfiguration
100 Mb/sMcDATA-CNT Ultranet Storage Director (USD)
ESCON
Firmware: 2.6.2-0 or 3.1
XP Continuous Access ESCON over IP
OpenVMS host-based volume shadowing
HP supports the following HP and third-party devices and features for OpenVMS host-based volume
shadowing:
• B-series1606 Extension SAN Switch and DC Dir Switch MP Extension Blade
• 400 MP Router, MP Router Blade
• B-series FC and FCIP Fastwrite
• Cisco PA-FC-1G
• C-series MDS IP Storage Services Module (IPS-4, IPS-8)
• Cisco MDS 14/2 Multiprotocol Services Module (including in MDS 9216i Fabric Channel switch
and gateway)
• Cisco MDS 18/4 Multiservice Module (including the MDS 9222i Multiservice Fabric switch and
gateway)
• C-series Write Acceleration
• CNT UltraNet 1000
• CNT UltraNet 1001
• CNT UltraNet 3000
• SR2122-2 IP Storage Router
Certified third-party WDM, iFCP, and SONET products
This section describes the following topics:
• Certified third-party WDM products, page 353
• Certified third-party iFCP and SONET products, page 353
SAN extension352
To Next Page
Loading...
