HP StorageWorks 4000/6000/8000 - Enterprise Virtual Arrays - Software Support; Management Software; Command View EVA Iscsi Connectivity Configuration 1

Software support
This section describes the software supported by the EVA iSCSI Connectivity Option.
Management software
The required minimum versions of Command View EVA management software are as follows:
• Command View 9.0.1 or later is required for EVA6400/8400.
• Command View 8.1 or later is required for array-based management.
• Command View 8.0.1 or later is required for EVA4400 (embedded switch) storage systems.
• Command View 8.0x or later is required for the mpx100/100b running firmware version 2.4x
or later.
• The EVA iSCSI Connectivity Options support Command View EVA iSCSI connectivity (Fibre
Channel switch not required).
See Figure 138 and Figure 139 and refer to the HP StorageWorks Command View EVA iSCSI
deployment white paper at http://h18006.www1.hp.com/storage/sanwhitepapers.html.
NOTE:
HP StorageWorks mpx Manager is required for mpx100/100b management.
FC1
FC2
GE1
GE2
MGMT
HP StorageWorks
mpx100
IOIOI
!
26484b
D1
GE1
MGMT
Discovery
IP address
Presented
iSCSI targets
D1 FP1B
FP1A
IP network
management
(WAN/LAN)
IP network
iSCSI data
(LAN/VLAN)
FC1 FC2
NIC
mpx100/100b
iSCSI initiator &
Command View
EVA server
EVA
Storage System
Figure 138 Command View EVA iSCSI connectivity configuration 1
.
SAN Design Reference Guide 371