2. Repeat Step 1 for the other feet.
2
1
1. Hex nut
2. Leveler foot
Figure 22 Raising a leveler foot
3. Carefully move the rack to the installation area and position it to provide the necessary service
areas (see Figure 21).
To stabilize the rack when it is in the final installation location:
1. Use a wrench to lower the foot by turning the leveler foot hex nut clockwise until the caster does
not touch the floor. Repeat for the other feet.
2. After lowering the feet, check the rack to ensure it is stable and level.
3. Adjust the feet as necessary to ensure the rack is stable and level.
HP StorageWorks 4400 Enterprise Virtual Array user guide 35
To Next Page
Loading...
Need help?
General