HP StorageWorks 4400 User Manual

5 Error messages
This list of error messages is in order by status code value, 0 to xxx.
Table 14 Error Messages
How to CorrectMeaningStatus Code Value
No corrective action required.
The SCMI command completed success-
fully.
0
Successful Status
Delete the associated object and
try the operation again. Several
situations can cause this message:
Presenting a LUN to a host:
• Delete the current association
or specify a different LUN
number.
Storage cell initialize:
• Remove or erase disk volumes
before the storage cell can be
successfully created.
Adding a port WWN to a host:
• Specify a different port WWN.
Adding a disk to a disk group:
• Delete the specified disk
volume before creating a new
disk volume.
The object or relationship already exists.
1
Object Already Exists
Report the error to product support.
The command or response buffer is not
large enough to hold the specified num-
ber of items. This can be caused by a
user or program error.
2
Supplied Buffer Too Small
Report the error to product support.
The handle is already assigned to an
existing object. This can be caused by
a user or program error.
3
Object Already Assigned
Reclaim some logical space or add
physical hardware.
There is insufficient storage available to
perform the request.
4
Insufficient Available Data
Storage
Report the error to product support.
An unexpected condition was en-
countered while processing a request.
5
Internal Error
Report the error to product support.This error is no longer supported.
6
Invalid status for logical disk
HP StorageWorks 4400 Enterprise Virtual Array user guide 79

HP StorageWorks 4400 Specifications

General

Brand	HP
Model	StorageWorks 4400
Category	Storage
Language	English