HP StorageWorks 4400 User Manual

How to CorrectMeaningStatus Code Value
Report the error to product support.
The supplied class code is of an un-
known type. This can be caused by a
user or program error.
7
Invalid Class
Report the error to product support.
The function code specified with the class
code is of an unknown type.
8
Invalid Function
Report the error to product support.
The specified command supplied unre-
cognized values. This can indicate a user
or program error.
9
Invalid Logical Disk Block State
Verify the hardware configuration
and retry the request.
The specified request supplied an invalid
loop configuration.
10
Invalid Loop Configuration
Report the error to product support.
There are insufficient resources to fulfill
the request, the requested value is not
supported, or the parameters supplied
are invalid. This can indicate a user or
program error.
11
Invalid parameter
In the following cases, the message
can occur because the operation
is not allowed when the storage
cell is in an uninitialized state. If
you see these messages, initialize
the storage cell and retry the oper-
ation.
Storage cell set device addition
policy
Storage cell set name
Storage cell set time
Storage cell set volume
replacement delay
Storage cell free command lock
Storage cell set console lun id
The supplied handle is invalid. This can
indicate a user error, program error, or
a storage cell in an uninitialized state.
In the following cases, the storage cell
is in an uninitialized state, but no action
is required:
Storage cell discard (informational
message):
Storage cell look up object count
(informational message):
Storage cell look up object (informational
message):
12
Invalid Parameter handle
Report the error to product support.
The supplied identifier is invalid. This can
indicate a user or program error.
13
Invalid Parameter Id
Report the error to product support.
Quorum disks from multiple storage sys-
tems are present.
14
Invalid Quorum Configuration
Case 1: Report the error to product
support.
Case 2: To add additional
capacity to the disk group, use the
management software to add disks
by count or capacity.
The supplied target handle is invalid.
This can indicate a user or program error
(Case 1),
or
Volume set requested usage (Case 2):
The operation could not be completed
because the disk has never belonged to
a disk group and therefore cannot be
added to a disk group.
15
Invalid Target Handle
Error messages80

HP StorageWorks 4400 Specifications

General

Brand	HP
Model	StorageWorks 4400
Category	Storage
Language	English