EasyManua.ls Logo

HP StorageWorks P9000

HP StorageWorks P9000
333 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Table 50 Error codes (part code 6005) (continued)
Severity LevelRecommended ActionError MessageError
Number
Part
Code
WVerify the following
conditions for the M-VOL
and R-VOL are met:
The emulation type is
corresponding.
The capacity is
corresponding.
If LUSE volume, the
capacity that each
volume combined in LUSE
are corresponding.
If mainframe system, the
capacity of copy target
is larger than that of copy
source.
The operation failed because the status
of specified volume as following:
The emulation type of M-VOL and
R-VOL do not match.
The capacity of M-VOL and R-VOL
do not match.
If LUSE volume is specified, the
capacity that each volume combined
in LUSE does not match.
87616005
WCheck the device cache
status of R-VOL from host. If
it is off, set it on and retry. If
it cannot be set on, please
contact HP Technical
Support.
R-VOL Device Cache status is not active.87626005
WCheck the DFW status of the
R-VOL from the host. If it is
off, set it on and retry. If it
cannot be set on, please
contact HP Technical
Support.
R-VOL DFW status is not active.87636005
WConfirm the status of the
specified R-VOL.
The specified R-VOL is not usable.87646005
WThe device emulation type
of the R-VOL does not
support Continuous Access
Synchronous. Please contact
HP Technical Support.
Remote Copy is not supported under
the R-VOL Device emulation type.
87666005
WThe RCU containing the
R-VOL is being used as the
RCU for Continuous Access
Synchronous. Verify the
status of the RCU, if
necessary delete the RCU,
then retry the operation.
The RCU is still in another Remote Copy
condition.
87686005
WThe RCU containing the
R-VOL is being used as the
RCU for Continuous Access
Synchronous. Verify the
status of the RCU.
The RCU is still in another Remote Copy
condition.
87696005
WClick [OK] to acknowledge
the message, then retry the
operation after the cache
has been recovered.
The Cache on the MCU is automatically
recovering. Please wait a few minutes
then retry again.
87706005
146 Message (part code group 6nnn)

Table of Contents

Other manuals for HP StorageWorks P9000

Related product manuals