HP StorageWorks P9000

Table 50 Error codes (part code 6005) (continued)
Severity LevelRecommended ActionError MessageError
Number
Part
Code
WThe specified volume is not
part of a Continuous Access
Synchronous pair. Check the
volume.
Specified volume is not part of Remote
Copy pair (Not in Duplex(PAIR),
Pending(COPY), Suspend(PSUS) state).
88496005
WCheck the serial number,
SSID, link address and
controller ID of the RCU, and
set the correct value. Then
retry the operation. If the
same error occurs, please
contact HP Technical
Support.
Invalid RCU serial number, SSID, Link
Address or Controller ID.
88506005
WRefresh the window, and
check whether the specified
volume is a R-VOL.
The specified volume is not a R-VOL.88516005
WConfirm the R-VOL status.R-VOL status change failed after M-VOL
status change. Confirm R-VOL status.
88526005
WThe operation failed,
because of one of the
following reasons:
• The specified volume is
simplex.
• There is no duplex,
duplex-pending, or
suspend volume in the
group.
Verify the volume status, and
retry the operation.
Delete Pair(Pairsplit-S) operation failed
because M-VOL is in Simplex(SMPL)
status.
88546005
WThe operation failed,
because of one of the
following reasons:
• The status of the specified
volume or another
volume in the same group
is Deleting.
• The status of the specified
volume or another
volume in the same group
is Suspending.
Wait for the transition of
status to complete, then retry
the operation.
If the transition of status does
not occur, delete the volume
by using the "Force" mode
or the "Delete pair by force"
option.
Delete(Pairsplit-S) operation failed
because specified volume or other
volume in the same group is in status
transition.
88556005
EPlease contact HP Technical
Support.
An internal error occurred.88606005
EPlease contact HP Technical
Support.
An internal error occurred.88616005
Part code 6005 153