HP StorageWorks P9000 - Page 152

Table 50 Error codes (part code 6005) (continued)
Severity LevelRecommended ActionError MessageError
Number
Part
Code
WSuspend mode is not valid
for the R-VOL. Check the
volume, and retry.
Suspend(Pairsplit-r) operation is not
valid for R-VOL.
88406005
WRefresh the window, and
check whether the specified
volume is a R-VOL.
The specified volume is not a R-VOL.88416005
WConfirm the R-VOL status.R-VOL status change failed after M-VOL
status change. Confirm R-VOL status.
88426005
WThe operation failed,
because of one of the
following reasons:
• The specified volume is
simplex.
• There is no duplex or
duplex-pending volume
in the group.
• Either the specified
volume or another
volume in the same group
is suspended.
Verify the volume status, and
retry the operation.
Suspend(Pairsplit-r) operation failed
because specified volume or other
volume in the same group is not in
permissible status.
88436005
WThe operation failed,
because of one of the
following reasons:
• The specified volume or
another volume in the
same group is deleting.
• The specified volume or
another volume in the
same group is
suspending.
Wait for the change in status
to be completed, then retry
the operation.
Suspend(Pairsplit-r) operation failed
because specified volume or other
volume in the same group is in status
transition.
88446005
iCancel the preset suspension
in the CT group, then retry
the operation.
Preset Suspension is effective in the CT
Group.
88456005
EPlease contact HP Technical
Support.
An internal error occurred.88466005
EPlease contact HP Technical
Support.
An internal error occurred.88476005
WThe suspend pair (Pairsplit-r)
operation failed. A few
minutes later, refresh the
window, confirm if the
specified volumes are in the
permissible status, then retry
the operation.
Please wait a few minutes and retry the
Suspend Pair(Pairsplit-r) operation.
88486005
152 Message (part code group 6nnn)