HP StorageWorks P9000

Table 50 Error codes (part code 6005) (continued)
Severity LevelRecommended ActionError MessageError
Number
Part
Code
WTake the following actions:
Specify only one CU# for
the same LCP of the RCU.
Connect to the LCP that can
access the specified R-VOL.
The LCP of the RCU cannot access the
specified R-VOL.
88296005
WCheck the status of the
specified M-VOL (P-VOL)
from HOST or SVP.
The specified M-VOL is already used
as a reserved volume of Auto LUN.
88306005
WCheck the status of the
specified R-VOL (S-VOL) from
HOST or SVP.
The specified R-VOL is already used as
a reserved volume of Auto LUN.
88316005
WCheck the status of the
specified M-VOL (P-VOL),
then retry the Add Pair
(Paircreate) / Resume Pair
(Pairresync) operation in a
few minutes.
Please wait a few minutes and retry the
Add Pair (Paircreate) / Resume Pair
(Pairresync) operation.
88326005
WCheck the status of the
specified R-VOL (S-VOL),
then retry the Add Pair
(Paircreate) / Resume Pair
(Pairresync) operation in a
few minutes.
Please wait a few minutes and retry the
Add Pair (Paircreate) / Resume Pair
(Pairresync) operation.
88336005
WSee the license key and
confirm the licensed
capacity of the volumes. To
create more pairs, purchase
a license key that allows you
to use a larger capacity.
The Add Pair (Paircreate) operation
failed because you tried to create
volume pairs which exceeded the
licensed capacity.
88346005
WSee the license key of the
RCU side, and confirm the
licensed capacity of the
volumes. To create more
pairs, purchase a license
key that allows you to use a
larger capacity.
The Add Pair (Paircreate) operation
failed because you tried to create
volume pairs which exceeded the
licensed capacity of the RCU side.
88356005
WCheck the pair status and
retry.
No additional volume pairs waiting for
copy.
88366005
EPlease contact HP Technical
Support.
An internal error occurred.88376005
WThe specified volume is not
part of a Continuous Access
Synchronous pair. Check the
volume.
Specified volume is not part of a
Remote Copy pair.
88386005
WCheck the serial number,
SSID, link address and
controller ID of the RCU, and
set the correct value. Then
retry the operation. If the
same error occurs, please
contact HP Technical
Support.
Invalid RCU serial number, SSID, Link
Address or Controller ID.
88396005
Part code 6005 151