HP StorageWorks P9000 - Page 178

Table 53 Error codes (part code 6505) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the serial number and the
controller ID of this remote storage
system and already registered remote
storage systems, then specify the correct
values.
If the specified values are correct, check
the cable connection of the remote
storage system. If the problem persists,
please contact HP Technical Support.
The serial number or the controller ID of
the remote subsystem is incorrect.
87196505
WReduce the number of registered remote
storage systems, then retry the operation.
The number of registered remote
subsystems already reached the
maximum (that is, 64).
87206505
WCheck the path connections between the
local and the remote storage systems,
then retry the operation.
Path creation has not finished yet.87216505
WCheck the path connections between the
local and the remote storage systems,
then retry the operation.
Path creation failed.87226505
WAdd another path, or delete all pairs on
the remote storage system. Then retry the
operation.
The Edit Path operation was rejected
because the specified path is the last
path of some Remote Copy pairs.
87236505
WCheck the number of paths.The specified number of paths is less
than the minimum number specified in
the DKC Option window.
87246505
WDo either of the following to recover from
the error:
• If the error code is 100c, add normal
paths, then set the minimum number
of paths.
• If the error code is 100d, add normal
paths, then delete paths. Alternatively,
reduce the minimum number of paths,
then delete paths.
The number of minimum paths exceeds
the number of normal paths.
87276505
WDo either of the following to recover from
the error:
• If the error code is 100c, add normal
paths, then set the minimum number
of paths.
• If the error code is 100d, add normal
paths, then delete paths. Alternatively,
reduce the minimum number of paths,
then delete paths.
The number of minimum paths exceeds
the number of normal paths.
87286505
ECheck the SSB log, then contact HP
Technical Support.
An internal error occurred.87296505
WDo either of the following to recover from
the error:
• If you are adding DKCs, specify the
same logical address.
• If you are editing paths, specify the
same logical address as the existing
paths.
The specified logical address is incorrect.87306505
178 Message (part code group 6nnn)