HP StorageWorks P9000

Table 53 Error codes (part code 6505) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WDelete the DKC once, then add the DKC
using the same logical address.
The existing logical addresses are not
the same.
87316505
WContinuous Access Journal or Continuous
Access Journal Z must be installed in the
storage system when you create a path
or a pair for Continuous Access Journal
or Continuous Access Journal Z. Install
Continuous Access Journal or Continuous
Access Journal Z in the storage system.
Continuous Access Journal or Continuous
Access Journal Z is not installed in the
storage system.
87336505
WContinuous Access Journal or Continuous
Access Journal Z must be installed in the
remote storage system when you create
a path or a pair for Continuous Access
Journal or Continuous Access Journal Z.
Install Continuous Access Journal or
Continuous Access Journal Z in the
remote storage system.
Continuous Access Journal or Continuous
Access Journal Z is not installed in the
remote storage system.
87346505
WCheck the serial number and the
controller ID of this remote storage
system and already registered remote
storage systems, then specify the correct
values.
If the specified values are correct, check
the cable connection of the remote
storage system. If the problem persists,
please contact HP Technical Support.
The serial number or the controller ID of
the remote subsystem is incorrect.
87356505
WDelete data volume pairs of the specified
remote storage system. Then delete
journals, if any. Ensure that there are no
data volume pairs and journals, then
retry the operation.
The specified remote storage system
contains journals or data volume pairs
for remote copy operations.
87366505
ECheck the SSB log, then contact HP
Technical Support.
An internal error occurred.87376505
WCheck the status of the pinned tracks in
the primary data volume, and clear the
pinned tracks.
Pinned track(s) exists in the primary data
volume.
87426505
WCheck the status of the pinned tracks in
the secondary data volume, and clear
the pinned tracks.
Pinned track(s) exists in the secondary
data volume.
87436505
WCheck whether the primary data volume
is in any of the following conditions:
• Data in the primary data volume is
being copied; correction copy or
drive copy is in progress.
• The primary data volume is in
correction access condition.
• The primary data volume is blocked.
• The primary data volume is being
maintained.
• The access attribute of the primary
data volume is Read Only.
The specified primary data volume
cannot be used.
87446505
Part code 6505 179