HP StorageWorks P9000

Table 53 Error codes (part code 6505) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EPlease contact HP Technical Support.An error occurred during the port
change.
89026505
EPlease contact HP Technical Support.Unknown Error Code.89036505
WCheck the status of the port, and retry
the operation.
Remote Web Console attempted to
change the port type. However, this
attempt was rejected because the same
operation was in progress from a host.
89156505
WCheck whether the primary storage
system supports remote copy via serial
interface. Install the microcode that
supports remote copy via serial interface,
or execute remote copy via fibre
interface.
The primary storage system does not
support remote copy function via the
serial interface.
89226505
wDelete the logical paths on the specified
port, and retry the operation.
Logical paths are defined to the port on
the remote subsystem.
89246505
WCheck the port type of the specified port,
and retry the operation.
Invalid port type.89296505
WDelete the logical paths on the specified
port, and retry the operation.
Logical paths are defined to the port on
the remote subsystem.
89306505
WDelete the logical paths on the specified
port, and retry the operation.
Logical paths are defined to the port on
the remote subsystem.
89316505
WCheck whether the specified LDKC
number is defined in the configuration
of the primary storage system.
Failed to create the logical path, because
the configuration definition of the
specified LDKC number did not exist in
the primary storage system.
89326505
WCheck the configuration of the specified
secondary data volume.
The Add Pair (Paircreate) operation
failed because the specified secondary
data volume was a NAS system volume.
89346505
WCheck the microcode version of the
secondary storage system.
The Paircreate (Add Pair) operation
failed. The microcode version of the
specified secondary subsystem does not
support Remote Copy with NAS volumes.
89366505
WCheck the access attribute of the
specified secondary data volume.
The specified secondary data volume is
unusable because of the access attribute
changed by Data Retention.
89446505
WCancel the definition of the external
volume, and retry the operation.
The external volume that is mapped to
an internal volume is connected to the
port.
89476505
WStop I/O operations, and retry.The specified port is receiving I/O
requests.
89486505
ECheck the SSB log, then contact HP
Technical Support.
An internal error occurred.89496505
ECheck the SSB log, then contact HP
Technical Support.
An internal error occurred.89506505
WCheck the status of the specified
secondary data volume.
The Add Pair (Paircreate) operation
failed because the specified secondary
data volume was used by XP Flex Copy.
89776505
Part code 6505 183