HP StorageWorks P9000

Table 53 Error codes (part code 6505) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the CLPR number of the registered
journal volume, and specify the volume
that has the same CLPR number.
The specified volume cannot be
registered as a journal volume because
the CLPR number of the specified volume
is different from the CLPR number of the
journal volume that has already been
registered.
583366505
WCheck the CLPR number of the journal
volume in the specified master journal,
then specify the primary data volume
that has the same CLPR number.
The operation failed, because the CLPR
number of the specified primary data
volume was different from the CLPR
number of the journal volume in the
specified master journal.
583376505
WCheck the CLPR number of the journal
volume in the specified restore journal
group, and specify the secondary data
volume that has the same CLPR number.
The operation failed because the CLPR
number of the specified secondary data
volume was different from the CLPR
number of the journal volume in the
specified restore journal group.
583386505
WCheck the specified volume and specify
a non-LUSE volume.
The specified volume cannot be used as
a journal volume because the specified
volume is an LUSE volume.
583406505
WCheck the specified volume and specify
a non-external volume.
The specified volume cannot be used as
a journal volume because the specified
volume is an external volume.
583416505
WCheck the setting of the volume in the
Data Retention window or the Volume
Retention window.
The specified volume cannot be used as
a journal volume because of a Data
Retention setting or a Volume Retention
setting.
583426505
WCheck the setting of the specified volume
in the Volume Security for Mainframe
window.
The specified volume cannot be used as
a journal volume because of a Volume
Security for Mainframe setting.
583436505
WCheck the specified secondary data
volume and specify a non-LUSE volume.
The Add Pair (Paircreate) operation
failed because the specified secondary
data volume is an LUSE volume.
583446505
WBe sure that IO suppression mode of the
specified secondary data volume is
enabled on the Universal Volume Mgr
window. If the IO suppression mode is
disabled, check the microcode version
of DKCMAIN of the secondary storage
system, and contact HP Technical
Support.
The Add Pair (Paircreate) operation
failed due to one of the following
reasons:
• The IO suppression mode of the
specified secondary data volume is
enabled.
• The microcode version of the
secondary storage system does not
support external volumes.
583456505
WFrom the Data Retention window, check
the settings of the specified secondary
data volume.
The Paircreate operation failed because
a Data Retention VMA was set up on the
specified secondary data volume.
583466505
WCheck the setting of the specified
secondary data volume in the Volume
Security for Mainframe window.
The Add Pair (Paircreate) operation
failed because of a Volume Security for
Mainframe setting on the specified
secondary data volume.
583476505
WFrom the Data Retention window, check
the settings of the specified primary data
volume.
The Paircreate operation failed because
a Data Retention VMA was set up on the
specified primary data volume.
583486505
Part code 6505 193