HP StorageWorks P9000

Table 53 Error codes (part code 6505) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WRetry the operation.
If this problem persists, please contact
HP Technical Support and request to
format the volume.
The specified volume cannot be
registered because the volume has failed
to recover from blockade. Please retry
the operation.
If this problem persists, please contact
HP Technical Support and request to
format the volume.
585636505
WConfirm that the shredding has
completed in the Data Retention window,
then retry the operation.
The Add Pair (Paircreate) operation
failed because the specified primary
data volume was being shredded by
Data Retention. Retry the operation after
the shredding is completed.
585646505
WConfirm that the shredding has
completed in the Data Retention window,
then retry the operation.
The Add Pair (Paircreate) operation
failed because the specified secondary
data volume was being shredded by
Data Retention. Retry the operation after
the shredding is completed.
585656505
WConfirm that the shredding has
completed in the Data Retention window,
then retry the operation.
The specified volume cannot be
registered as a journal volume because
the volume is being shredded by Data
Retention.
Retry the operation after the shredding
is completed.
585666505
WCheck the journal volumes statuses of the
specified master journal.
The operation of Add Pair (Paircreate)
or the Resume Pair (Pairresync) failed,
because the journal volumes of the
specified master journal were blocked.
585906505
WCheck the journal volumes statuses of the
specified restore journal.
The operation of Add Pair (Paircreate)
or the Resume Pair (Pairresync) failed,
because the journal volumes of the
specified restore journal were blocked.
585916505
WCheck the status of the storage system.
Retry the operation after the storage
system has started.
The specified operation failed because
the subsystem was being powered on or
powered off.
585926505
WWait for a while, and refresh the
window. If this message is displayed
after a setting operation, check whether
the setting is reflected. When the setting
is not reflected, retry the operation.
The storage system has accepted the
request normally, however the processing
requires some time. If this message is
displayed after a setting operation,
please refresh the window and check
whether the setting is reflected. If the
setting is not reflected despite refreshing
the window, please retry the operation.
585936505
WCheck the LUSE volume configuration of
the primary data volume and the
secondary data volume.
The Paircreate operation failed because
the configuration of the LUSE volume was
different between the primary data
volume and the secondary data volume.
585946505
WConfirm that the Continuous Access
Journal function of the secondary storage
system supports LUSE volumes.
The Paircreate operation failed because
the Continuous Access Journal function
of the secondary subsystem does not
support LUSE volumes.
585956505
198 Message (part code group 6nnn)