Table 53 Error codes (part code 6505) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the number of remote command
devices which has been assigned to a
mirror.
The operation failed, because the
number of assignable remote command
device to a mirror exceeded the
maximum.
688636505
WCheck if a remote command device was
assigned to the specified mirror.
The operation failed, because a remote
command device was not assigned to
the specified mirror.
688706505
WRelease the quorum disk, or select
another volume.
The operation failed, because the
specified volume was a quorum disk.
688856505
WConfirm whether the remote storage
system supports the specified operation.
The operation failed, because the remote
storage system did not support the
specified operation.
688866505
WConfirm the relationship status of
Compatible FlashCopy and the pair
status of Continuous Access Synchronous
Z.
The operation failed, because the
specified primary data volume was as
follows:
• This volume was used as T-VOL of
Compatible FlashCopy.
• This volume was used as M-VOL of
Continuous Access Synchronous Z,
and it was suspended by either of the
following settings:
• It was a pair of synchronous
consistency group.
• It was a pair that the "Cylinder" was
set to "Difference Management."
688876505
WConfirm the relationship status of the
Compatible FlashCopy.
The operation failed, because the
specified "primary data volume" was
used as T-VOL of Compatible FlashCopy
that might be in the abnormal state due
to a failure.
688886505
WSpecify LDEVs defined in the same
resource group.
The specified operation cannot be done
because there is an LDEV that has been
set to a different resource group.
750216505
WCheck the specified journal.The specified journal cannot be used.780036505
WCheck the specified consistency group.The specified consistency group cannot
be used.
780046505
WCheck the specified capacity of the
primary data volume and the current
microcode version.
The operation failed because the
specified capacity of the primary data
volume is not supported by the current
microcode version.
780506505
WCheck the specified capacity of the
secondary data volume and the current
microcode version.
The operation failed because the
specified capacity of the secondary data
volume is not supported by the current
microcode version.
780516505
EPlease contact HP Technical Support.The operation failed. The Mainframe
Fibre CHA of RCU is not mounted or all
the Mainframe Fibre CHA are blocked.
780666505
214 Message (part code group 6nnn)
To Next Page
Loading...
