HP StorageWorks P9000

Table 62 Error codes (part code 7105) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EThere is insufficient shared memory in
DKC. Please contact HP Technical
Support.
There is insufficient shared memory to
create 4096 pairs.
85397105
EPlease contact HP Technical Support.There is sufficient shared memory to
create 4096 pairs, but initial subsystem
setup is required before creating pairs.
85407105
iClose the message box.There is sufficient shared memory to
create 4096 pairs, and the initial
subsystem setup is complete.
85417105
EPlease contact HP Technical Support.Failed to complete the initial shared
memory setup.
85427105
EPlease contact HP Technical Support.The shared memory size is different.85437105
WCheck the contents, and retry.16 Mbytes of shared memory is
available.
85447105
EPlease contact HP Technical Support.A power supply failure is detected.85457105
WRetry the operation with power ON.The command was rejected. The PS OFF
is in progress.
85467105
EPlease contact HP Technical Support.A data transfer failure is detected (CHA).85477105
EPlease contact HP Technical Support.A data transfer failure is detected (DKA).85487105
WYou cannot execute the operation for the
volume which is not implemented.
The S-VOL is not implemented.85497105
E
• Restore the blocked volume, then retry
the operation.
• The system disk cannot be specified
as an S-VOL. Specify another volume.
The command has been rejected,
because the specified S-VOL is blocked
or used as a system disk.
85507105
WWait until the volume is formatted, and
retry the operation.
The S-VOL is being formatted.85517105
WAs the S-VOL, specify a volume that is
not used as a command device.
This volume cannot be specified as an
S-VOL because it is used as a command
device.
85527105
WYou cannot execute the operation for the
volume which is not implemented.
The T-VOL is not implemented.85537105
W
• Restore the blocked volume, then retry
the operation.
• The system disk cannot be specified
as a T-VOL. Specify another volume.
The command has been rejected,
because the specified T-VOL is blocked
or used as a system disk.
85547105
WWait until the volume is formatted, and
retry the operation.
The T-VOL is being formatted.85557105
WRelease the command device, then retry
the operation.
This volume cannot be specified as an
T-VOL because it is used as a command
device.
85567105
WYou cannot execute the operation for the
volume which is not implemented.
The volume is not implemented.85577105
Part code 7105 255