HP StorageWorks P9000

Table 62 Error codes (part code 7105) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
E
• Restore the blocked volume, then retry
the operation.
• The system disk cannot be specified
as a reserved volume. Specify another
volume.
The command has been rejected,
because the specified volume is blocked
or used as a system disk.
85587105
WWait until the volume is formatted, and
retry the operation.
The volume is being formatted.85597105
WSpecify a volume that is not used as a
command device.
This volume cannot be specified because
it is used as a command device.
85607105
EPlease contact HP Technical Support.The command code is invalid.85617105
EIf this problem persists please contact HP
Technical Support.
The command code sender is invalid.85627105
WPlease contact HP Technical Support.The volume type is invalid.85637105
WPlease contact HP Technical Support.The volume type is invalid.85647105
ECheck the contents, and retry.The command code sender is invalid.85657105
ECheck the contents, and retry.The attribute of the reserved volume is
invalid.
85667105
EPlease contact HP Technical Support.The number of effective lists is invalid.85677105
WSpecify the volume of the supported
emulation type.
The emulation type is invalid.85687105
WSee the section "Planning number of
pairs" in the HP StorageWorks P9000
Business Copy for Mainframe Systems
User Guide for the relation between the
number of pairs that can be created and
the shared memories.
The command has been rejected,
because the area of the differential table
or pair table to set pairs is insufficient.
85697105
WRefresh the window, and retry the
operation.
The selected volume does not exist.85707105
WCheck the contents, and retry.The volume is already defined as a
reserved volume.
85717105
WCheck the contents, and retry.The volume is already defined as S-VOL.85727105
WRelease the Auto LUN setting.The volume is defined as a source
volume for Auto LUN.
85737105
WRelease the Auto LUN setting.The volume is defined as a target volume
for Auto LUN.
85747105
WCheck the status of the volume.The selected volume is not a reserved
volume.
85757105
WCheck the contents, and retry.No reserved volume is available for use.85767105
WStop the operation of the Reserve volume
setting, or delete the Reserve volume.
The number of reserved volumes to be
defined exceeds the maximum.
85777105
WCheck the contents, then retry the
operation.
The S-VOL is already paired with a
backup volume. Therefore, it cannot be
paired with the target volume.
85787105
WDefine the reserve volume, then retry the
operation.
No volume is defined as a reserved
volume.
85797105
256 Message (part code group 7nnn)