HP StorageWorks P9000 - Page 257

Table 62 Error codes (part code 7105) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WYou cannot use the volume. Specify other
volume, and retry the operation.
The specified volume is for backup
servers only.
85807105
WCheck the contents, and retry.The specified volume is not for backup
servers only.
85817105
WWait a while, and retry the operation.The emulation type of the target volume
is being changed.
85827105
WSpecify the volume of the supported RAID
level.
The RAID level of the specified volume
is not supported.
85837105
WDefine the reserve volume, then retry the
operation.
No volume is defined as a reserved
volume.
85847105
WStop the operation of the Reserve volume
setting, or delete the Reserve volume.
The number of reserved volumes exceeds
the maximum.
85857105
WCheck the contents, and retry.The number of groups that can be set in
the same subsystem is invalid.
85867105
WCheck the contents, and retry.The number of pairs that can be set in
the same group is invalid.
85877105
WCheck the contents, and retry.The specified group number is not set.85887105
WCheck the contents, and retry.The specified group name is invalid.85897105
WCheck the contents, and retry.The group name and the number do not
match.
85907105
WCheck the contents, and retry.The specified pair is already set in
another group.
85917105
WCheck the capacity of the installed
license key. To create more pairs,
purchase a license key for larger
capacity.
The command was rejected because the
licensed capacity was exceeded.
85927105
WRelease the Auto LUN setting.The S-VOL is a source volume for Auto
LUN.
85937105
WRelease the Auto LUN setting.The S-VOL is a target volume for Auto
LUN.
85947105
WRefresh, then retry the operation.The specified S-VOL does not exist.85957105
WCheck the status of the volume.The specified volume is a reserved
volume.
85967105
WPairs cannot be created with the
specified S-VOL any more.
See the section "Volume pairs (S-VOLs
and T-VOLs)" in the HP StorageWorks
P9000 Business Copy for Mainframe
Systems User Guide for the composition
of pairs.
The command has been rejected,
because the number of pairs created with
the specified S-VOL has reached the
maximum.
85977105
WCheck the status of the volume.The specified volume is not an S-VOL.85987105
WSpecify other P-VOL, and retry the
operation. Or delete the pair of the
specified volume, then retry the
operation.
The specified volume is already an
S-VOL.
85997105
Part code 7105 257