Table 26 Error codes (part code 01022) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the setting(s).The specified host name cannot be
added because it is already used in the
same port, or it exists in the [Selected
Hosts] table.
10502501022
WCheck if there is a target host to be set
in the [Selected Hosts] table. When there
is not, add host(s) and retry the
operation. When there is, close the
window(s) and refresh it, then retry
again. If the same problem persists
despite retrying, please contact HP
Technical Support.
The processing cannot be done because
of no data in the [Selected Hosts] table.
10502601022
WSelect one table row.[Detail] is clicked in the state that no row
is selected.
10502701022
WSelect one table row.[Detail] is clicked in the state that multiple
rows are selected.
10502801022
WCheck the setting(s).Host groups cannot be added in this
port, because the port is not Target or
RCU Target.
10502901022
WCheck the setting(s).No more host group can be added,
because the number of registered host
groups that can be added to the subject
port has reached the maximum.
10503001022
WSelect one or more rows in the [Available
Hosts] table and the [Available Ports]
table, then click [Add].
The host group cannot be added
because no row is selected in any of the
[Available Hosts] table and the
[Available Ports] table.
10503101022
WCheck the setting(s).No more host group can be added,
because the number of registered hosts
that can be added to the subject port has
reached the maximum.
10503301022
WEnter the host group name with up to 64
alphanumeric characters and symbols (\
/: , ; * ? "< > | are excluded).
The specified name of the host group is
incorrect.
10503701022
WSpecify another host group name.The default host group name cannot be
used for the host group setting.
10503801022
WSelect one table row.[Detail] is clicked without selecting a
table row.
10504001022
WSelect one table row.[Detail] is clicked in the state of selecting
multiple table rows.
10504101022
WSelect one or more table rows.[Delete] is clicked without selecting any
row.
10504201022
WCheck if any of target host group to be
set exists in the [Selected Host Groups]
table. When there is not, add host
group(s) and retry the operation. When
there is, close the window(s) and refresh
it, then retry again. If the same problem
persists despite retrying, please contact
HP Technical Support.
The processing cannot be done because
there is no data in the [Selected Host
Groups] table.
10504301022
WSelect one table row.[Detail] is clicked without selecting table
rows.
10504401022
64 Message (part code group 1nnn)
To Next Page
Loading...
