HP StorageWorks P9000 - Zoned Decimal Conversion (NUM:OPA2)

Table 26 Error codes (part code 01022) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WSelect one table row.[Detail] is clicked in the state of selecting
multiple table rows.
10504501022
WSpecify the HBA WWN with 16 digits
in hexadecimal.
HBA WWN cannot be converted into
hexadecimal.
10504601022
WEnter the host name within 1 to 64
characters.
The length of the host name is incorrect.10504701022
WRemove the invalid characters, then retry.An invalid character is used in the host
name.
10504801022
WCheck the setting(s).You are trying to register the same host
that has already existed as a candidate.
10504901022
WCheck the setting(s).The specified HBA WWN cannot be
registered, because it is already used in
this port.
10505001022
WCheck the setting(s).The specified Host Name cannot be
registered, because it is already used in
this port.
10505101022
WCheck the setting(s).There is no port information on the copy
target.
10505201022
WCheck the setting(s).The same host is specified at the same
time.
10507001022
WCheck the setting(s).The attribute of the specified port is
neither Target nor RCU Target.
10507101022
WCheck the setting(s).The same host cannot be added in the
same port.
10507201022
WCheck the setting(s).[Finish] is clicked without completing the
setting.
10507301022
WCheck the check boxes for the items that
you want to change, then retry the
operation.
All the check boxes are being cleared.10507401022
WCheck the setting(s).The HBA WWN about to be changed
has already existed in the same port.
10507501022
WCheck the setting(s).The host name about to be changed has
already existed in the same port.
10507601022
WCheck the setting(s).The specified port type is not Fibre Port.10507701022
WCheck the setting(s).Changing to the external or the initiator
port cannot be done, because a host
group other than Host Group 0 is set.
10507901022
WCheck the setting(s).Changing to External or Initiator port
cannot be done, because a host or a
path is set.
10508001022
WCheck the channel PCB.The setting cannot be changed because
of the unsupported port speed.
10508101022
ERetry the operation. If the same problem
occurs again, close the windows, refresh
it, then retry again. If the same problem
persists despite retrying, please contact
HP Technical Support.
The specified port does not exist in the
configuration.
10508201022
Part code 01022 65