Table 35 Error codes (part code 03122) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WRestore the blocked status of the pools.There are no valid volumes, because the
pools are blocked.
10604103122
WCheck the pool capacity, the maximum
reserved capacity, and the current
reserved capacity, then retry the
operation.
The shrinking operation cannot be
performed on the specified pool.
10604203122
WDelete the pool.The pool cannot be restored.10606203122
WExecute any of the following actions,
then retry the operation.
• Increase the pool capacity by adding
pool volume(s).
• Reduce the pool usage.
The pool cannot be restored.10606303122
WBlock the pool.The pool cannot be restored.10606403122
WInstall the necessary program product.The specified function is not available
because the necessary program product
is not installed.
10607803122
WCheck the specified value of the
subscription limit, then retry the
operation.
The operation cannot be done because
there is no pool that can be associated
with a Thin Provisioning volume (V-VOL).
10608703122
WCheck the setting of depletion threshold
and warning threshold, then retry the
operation.
The depletion threshold is set lower than
the warning threshold.
10609003122
WCheck the setting of warning threshold,
then retry the operation.
The warning threshold is not input.10609103122
WCheck the setting of the depletion
threshold, then retry the operation.
The depletion threshold is not input.10609303122
WTo continue the processing, click [OK].
Otherwise, click [Cancel].
More than one drive type is used
between the LDEVs selected for the pool
volumes. When different drive types are
used together in the same pool, the
performance will be impacted by the
lowest performing drive type. Confirm
that selected LDEVs with a mix of drive
types are OK?
10609403122
WCheck the configuration of the pools.The operation cannot be done because
the configuration of the specified pools
does not meet the conditions below.
• The smart pool is enabled.
• The tier management is in manual
operation.
10609503122
WCheck the status of the pool, and then
retry the operation.
Failed to get the pool information.10609603122
WCheck the status of the pool, and then
retry the operation.
The operation cannot be done because
the specified pool is in monitoring
operation.
10609703122
WCheck the status of the pool, and then
retry the operation.
The operation cannot be done because
the specified pool is calculating the
monitor information.
10609803122
98 Message (part code group 3nnn)
To Next Page
Loading...
