HP StorageWorks User Manual

External Storage XP user guide 105
Connecting TagmaStore AMS and TagmaStore WMS subsystems
System parameters for connecting TagmaStore AMS and TagmaStore WMS subsystems
Table 16 explains whether to specify system parameters when making settings for ports on TagmaStore
AMS and TagmaStore WMS subsystems.
NOTE: You can either specify or omit any other parameters.
Table 16 System parameter settings (TagmaStore AMS and TagmaStore WMS subsystems)
Pane name Parameters Parameter setting
Boot Options Start Attribute
• Single Mode Specify this parameter when the TagmaStore
AMS or TagmaStore WMS subsystem is in
the one-controller configuration.
• Dual Active Mode Specify this parameter when the TagmaStore
AMS or TagmaStore WMS subsystem is in
the two-controller configuration.
Delay Planned Shutdown You can either specify this parameter or omit
specifying this parameter.
Drive blocking mode You can either specify this parameter or omit
specifying this parameter.
Vendor ID Keep this parameter as HITACHI (default),
and do not change.
Product ID Keep this parameter as DF600F (default),
and do not change.
ROM Microprogram Version You can either specify this parameter or omit
specifying this parameter.
RAM Microprogram Version You can either specify this parameter or omit
specifying this parameter.
System Parameter Option You can either specify this parameter or omit
specifying this parameter.
Operation if the processor failure occurs Set this parameter to Reset of occurred.
WEB Title You can either specify this parameter or omit
specifying this parameter.
Write and verify mode Set this parameter to ON.
Port Options Port Option You can either specify this parameter or omit
specifying this parameter.
Host Connection
Mode
Host Connection Mode 1 Set this parameter to Standard Mode.
Host Connection Mode 2 Do not specify any parameters.
NOTE: Do not specify HISUP OFF mode,
either.

HP StorageWorks Specifications

General

Brand	HP
Model	StorageWorks
Category	Storage
Language	English