External Storage XP user guide 57
Configuring external LUs
To use external storage devices connected to the local disk array, configure the connection to the external
LU. This involves setting port attributes on the local and/or external arrays, mapping external LUs, and
setting alternate paths.
This section describes procedures for using External Storage XP to configure external LUs.
• ”Overview of configuring external LUs” on page 58
• ”Setting an external disk array’s port” on page 59
• ”Setting a local disk array’s port attributes” on page 59
• ”Mapping external LUs (Add LU)” on page 60
• ”Setting alternate paths for external LUs” on page 74
• ”Adding alternate paths to multiple external LUs (Add Paths)” on page 79
• ”Deleting alternate paths for multiple external LUs (Delete Paths)” on page 80
• ”Checking an external LU’s status (LDEV Information)” on page 82
• ”Disconnecting external disk arrays or external LUs” on page 85
• ”Checking the connection status and resuming external LU operations (Check Paths & Restore Vol.)” on
page 87
• ”Restoring external LUs (LDEV Restore)” on page 88
• ”Stopping the use of paths to an external LU by specifying an external disk array’s WWN (Disconnect
Paths)” on page 89
• ”Restoring paths to an external LU by specifying an external disk array’s WWN (Check Paths)” on
page 89
• ”Changing an external disk array’s port setting” on page 90
• ”Stopping the use of paths to an external LU by specifying a local disk array’s port (Disconnect Paths)”
on page 91
• ”Restoring paths to an external LU by specifying a local disk array’s port (Check Paths)” on page 91
• ”Deleting external LU mappings (Delete LU)” on page 92
To Next Page
Loading...
Need help?
General