HPE Apollo 4200 Gen10 Plus

5. Remove the air baffle.
Removing and replacing the cable management armRemoving and replacing the cable management arm
WARNING:WARNING:
To reduce the risk of personal injury or damage to the equipment, you must adequately support the chassis during
installation and removal.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend the server from the rack .
4. Remove the cables from the cable management arm.
HPE Apollo 4200 Gen10 Plus Server Maintenance and Service Guide 23