To replace the component, reverse the removal procedure.
Removing and replacing the OCP fan boardRemoving and replacing the OCP fan board
WARNING: WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components
to cool before touching them.
CAUTION: CAUTION: To prevent damage to electrical components, take the appropriate anti-static precautions before beginning
any installation, removal, or replacement procedure. Improper grounding can cause electrostatic discharge.
CAUTION:CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all PCIe slots have either an
expansion slot cover or an expansion card installed.
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items:
Components included with the hardware kit
T-10 screwdriver
ProcedureProcedure
1. Power down the server.
2. Remove the server from the rack .
3. Place the server on a flat, level surface.
4. Remove the complete access panel .
5. Remove drive cage 4.
6. Remove the OCP fan board.
To Next Page
Loading...
