CAUTION: CAUTION: To prevent damage to electrical components, take the appropriate anti-static precautions before beginning
any installation, removal, or replacement procedure. Improper grounding can cause electrostatic discharge.
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the components included with the hardware kit.
ProcedureProcedure
1. Power down the server.
2. Remove the server from the rack .
3. Place the server on a flat, level surface.
4. Remove the complete access panel .
5. Disconnect all cables connected to the storage controller.
6. Remove the storage controller.
7. Configure the new storage controller.
For more information, see the user guide for your controller series on the Hewlett Packard Enterprise website (
http://www.hpe.com/info/smartstorage-docshttp://www.hpe.com/info/smartstorage-docs).
To replace the component, reverse the removal procedure.
Removing and replacing the Removing and replacing the HPEHPE NS204i-p NVMe OS Boot Device NS204i-p NVMe OS Boot Device option option
Removing and replacing the Removing and replacing the boot deviceboot device
PrerequisitesPrerequisites
ProcedureProcedure
1. Observe the following alerts:
CAUTION:CAUTION:
To Next Page
Loading...
