EasyManua.ls Logo

HPE FlexFabric 5950 Series

HPE FlexFabric 5950 Series
451 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
357
Table 33 Interface and IP address assignment
Device Interface IP address Device Interface IP address
CE 1 Loop0 100::1/96 CE 3 Loop0 200::1/96
Vlan-int2 10:1::1/96 Vlan-int7 10:3::1/96
CE 2 Vlan-int2 10:2::1/96 PE 2 Loop0 2.2.2.9/32
PE 1 Loop0 1.1.1.9/32 Vlan-int2 10:2::2/96
Vlan-int2 10:1::2/96 Vlan-int4 40.1.1.2/24
Vlan-int3 30.1.1.1/24 Vlan-int5 50.1.1.1/24
Vlan-int4 40.1.1.1/24 P Loop0 3.3.3.9/32
PE 3 Loop0 4.4.4.9/32 Vlan-int3 30.1.1.2/24
Vlan-int6 60.1.1.2/24 Vlan-int5 50.1.1.2/24
Vlan-int7 10:3::2/96 Vlan-int6 60.1.1.1/24
553BConfiguration procedure
1. Configure basic IPv6 MPLS L3VPN:
{ Configure OSPF on the MPLS backbone to allow the PEs and P device to learn the routes
of the loopback interfaces from each other.
{ Configure basic MPLS and MPLS LDP on the MPLS backbone to establish LDP LSPs.
{ Establish an MP-IBGP peer relationship between the PEs to advertise VPN IPv6 routes.
{ Configure the VPN instance of VPN 1 on PE 1 to allow CE 1 to access the network.
{ Configure the VPN instance of VPN 1 on PE 2 to allow CE 2 to access the network.
{ Configure the VPN instance of VPN 1 on PE 3 to allow CE 3 to access the network.
{ Configure BGP as the PE-CE routing protocol, and redistribute routes of the CEs into the
PEs.
For more information about basic MPLS L3VPN configurations, see "
852HConfiguring IPv6 MPLS
L3VPNs."
2. Configure BGP AS number substitution:
# Configure BGP AS number substitution on PE 1, PE 2, and PE 3. For more information about
the configuration, see "
853HConfiguring BGP AS number substitution."
# Display routing information on CE 2. The output shows that CE 2 has learned the route
100::/96 from CE 1. A routing loop has occurred because CE1 and CE 2 reside in the same site.
<CE2> display bgp routing-table ipv6 peer 10:2::2 received-routes
Total number of routes: 2
BGP local router ID is 12.1.1.3
Status codes: * - valid, > - best, d - dampened, h - history,
s - suppressed, S - stale, i - internal, e - external
Origin: i - IGP, e - EGP, ? - incomplete
* >e Network : 100:: PrefixLen : 96
NextHop : 10:2::2 LocPrf :
PrefVal : 0 OutLabel : NULL
MED :
Path/Ogn: 100 100?

Table of Contents

Other manuals for HPE FlexFabric 5950 Series

Related product manuals