92
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Set the fixed-area ratio for a
queue.
buffer egress
[
slot
slot-number ]
cell queue
queue-id
guaranteed
ratio
ratio-value
The default setting is 12.5% for
each queue, but the default
value in the
display buffer
queue
command output is 12%.
Applying data buffer configuration
Perform this task to apply the data buffer configuration.
You cannot directly modify the applied configuration. To modify the configuration, you must cancel
the application, reconfigure data buffers, and reapply the configuration.
To apply data buffer configuration:
Step Command
1. Enter system view.
system-view
2. Apply data buffer configuration.
buffer apply
Displaying and maintaining data buffers
Execute display commands in any view.
Task Command
Display data buffer configuration.
display buffer
[
slot
slot-number ] [
queue
[
queue-id ] ]
Display data buffer usage.
display buffer usage
[
slot
slot-number ]