HPE FlexNetwork 5510 HI Series Acl And Qos Configuration Guide

4
Configuring an IPv4 basic ACL
IPv4 basic ACLs match packets based only on source IP addresses.
To configure an IPv4 basic ACL:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create an IPv4 basic ACL
and enter its view.
acl number
acl-number [
name
acl-name ] [
match-order
{
auto
|
config
} ]
By default, no ACL exists.
IPv4 basic ACLs are numbered in
the range of 2000 to 2999.
You can use the
acl name
acl-name command to enter the
view of a named ACL.
3. (Optional.) Configure a
description for the IPv4 basic
ACL.
description
text
By default, an IPv4 basic ACL has
no ACL description.
4. (Optional.) Set the rule
numbering step.
step
step-value The default setting is 5.
5. Create or edit a rule.
rule
[ rule-id ] {
deny
|
permit
}
[
counting
|
fragment
|
logging
|
source
{ source-address
source-wildcard |
any
} |
time-range
time-range-name |
vpn-instance
vpn-instance-name ] *
By default, an IPv4 basic ACL
does not contain any rule.
The
logging
keyword takes effect
only when the module (for
example, packet filtering) that
uses the ACL supports logging.
If an ACL is for outbound QoS
traffic classification or outbound
packet filtering, do not specify the
vpn-instance
keyword.
6. (Optional.) Add or edit a rule
comment.
rule
rule-id
comment
text
By default, no rule comments are
configured.
Configuring an IPv6 basic ACL
IPv6 basic ACLs match packets based only on source IP addresses.
To configure an IPv6 basic ACL:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create an IPv6 basic ACL
view and enter its view.
acl ipv6 number
acl-number
[
name
acl-name ] [
match-order
{
auto
|
config
} ]
By default, no ACL exists.
IPv6 basic ACLs are numbered in
the range of 2000 to 2999.
You can use the
acl ipv6 name
acl-name command to enter the
view of a named ACL.
3. (Optional.) Configure a
description for the IPv6 basic
ACL.
description
text
By default, an IPv6 basic ACL has
no ACL description.
4. (Optional.) Set the rule
numbering step.
step
step-value The default setting is 5.
5. Create or edit a rule.
rule
[ rule-id ] {
deny
|
permit
} By default, an IPv6 basic ACL

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English