HPE MSR1000 - Configuring a Port to Operate in Manual Voice VLAN Assignment Mode

22
Step
Command
Remarks
7. (Optional.) Enable the
voice VLAN security
mode.
voice-vlan security enable
By default, the voice VLAN
security mode is enabled.
8. (Optional.) Add an OUI
address for voice packet
identification.
voice-vlan mac-address
oui
mask
oui-mask [
description
text ]
By default, system default
OUI addresses exist.
9. Enter interface view.
• Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
• Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
• Enter S-channel interface view:
interface s-channel
interface-number.channel-id
• Enter S-channel aggregate interface
view:
interface schannel-aggregation
interface-number:channel-id
• Enter Layer 2 RPR logical interface
view:
interface rpr-bridge
interface-number
N/A
10. Set the link type of the
port.
• Set the port link type to trunk:
port link-type trunk
• Set the port link type to hybrid:
port link-type hybrid
N/A
11. Configure the port to
operate in automatic
voice VLAN assignment
mode.
voice-vlan mode auto
By default, the automatic
voice VLAN assignment
mode is enabled.
12. Enable the voice VLAN
feature on the port.
voice-vlan
vlan-id
enable
By default, the voice VLAN
feature is disabled.
Before you execute this
command, make sure the
specified VLAN already
exists.
Configuring a port to operate in manual voice VLAN assignment mode
Step
Command
Remarks
13. Enter system view.
system-view
N/A
14. (Optional.) Enable the
voice VLAN security
mode.
voice-vlan security enable
By default, the voice VLAN
security mode is enabled.
15. (Optional.) Add an OUI
address for voice packet
identification.
voice-vlan mac-address
oui
mask
oui-mask [
description
text ]
By default, system default OUI
addresses exist.