HPE MSR1000

109
<Sysname> system-view
[Sysname] ikev2 profile profile1
# Apply the IKEv2 profile profile1 to the interface whose IP address is 2.2.2.2.
[Sysname-ikev2-profile-profile1] match local address 2.2.2.2
Related commands
match remote
New command: match local address (IKEv2 policy view)
Use match local address to specify a local interface or a local address that an IKEv2 policy
matches.
Use undo match local address to remove a local interface or a local address that an IKEv2 policy
matches.
Syntax
match local address { interface-type interface-number | { ipv4-address | ipv6 ipv6-address } }
undo match local address { interface-type interface-number | { ipv4-address | ipv6 ipv6-address } }
Default
No local interface or address is specified, and the IKEv2 policy matches any local interface or
address.
Views
IKEv2 policy view
Predefined user roles
network-admin
Parameters
interface-type interface-number: Specifies a local interface by its type and number. It can be any
Layer 3 interface.
ipv4-address: Specifies the IPv4 address of a local interface.
ipv6 ipv6-address: Specifies the IPv6 address of a local interface.
Usage guidelines
IKEv2 policies with this command configured are looked up before those that do not have this
command configured.
Examples
# Configure the IKEv2 policy policy1 to match the local address 3.3.3.3.
<Sysname> system-view
[Sysname] ikev2 policy policy1
[Sysname-ikev2-policy-policy1] match local address 3.3.3.3