191
Modified feature: Enabling CWMP
Feature change description
The default CWMP status was changed from disabled to enabled.
To enable CWMP:
1. Enter system view.
system-view
N/A
2. Enter CWMP view.
N/A
3. Enable CWMP.
cwmp enable
By default, CWMP is enabled.
Command changes
Modified command: cwmp enable
Syntax
cwmp enable
undo cwmp enable
Views
CWMP view
Change description
Before modification: CWMP is disabled by default.
After modification: CWMP is enabled by default.
Release 0305
This release has the following changes:
New feature: IKE
Modified feature: IPsec
To Next Page
Loading...
